F

FHA strap- Metal straps that are used to repair
a bearing wall "cut-out", and to "tie
together" wall corners, splices, and bearing headers.
Also, they are used to hang stairs and landings to bearing
headers.
Face
nail- To install nails into the vertical face
of a bearing header or beam.
Faced
concrete- To finish the front and all vertical
sides of a concrete porch, step(s), or patio. Normally
the "face" is broom finished.
Facing
brick- The brick used and exposed on the outside
of a wall. Usually these have a finished texture.
Fascia- Horizontal boards attached to rafter/truss ends at the
eaves and along gables. Roof drain gutters are attached
to the fascia.
Felt-
Tar paper. Installed under the roof shingles. Normally
15 lb. or 30 lb.
Female- Any part, such as a nut or fitting, into which another
(male) part can be inserted. Internal threads are female.
Ferrule- Metal tubes used to keep roof gutters "open".
Long nails (ferrule spikes) are driven through these
tubes and hold the gutters in place along the fascia
of the home.
Field
measure- To take measurements (cabinets, countertops,
stairs, shower doors, etc.) in the home itself instead
of using the blueprints.
Finger
joint- A manufacturing process of interlocking
two shorter pieces of wood end to end to create a longer
piece of dimensional lumber or molding. Often used in
jambs and casings and are normally painted (instead
of stained).
Fire
block- Short horizontal members sometimes nailed
between studs, usually about halfway up a wall. See
also 'Fire stop'.
Fire
brick- Brick made of refractory ceramic material
which will resist high temperatures. Used in a fireplace
and boiler.
Fireplace
chase flashing pan- A large sheet of metal that
is installed around and perpendicular to the fireplace
flue pipe. It's purpose is to confine and limit the
spread of fire and smoke to a small area.
Fire-resistive
or Fire rated- Applies to materials that are
not combustible in the temperatures of ordinary fires
and will withstand such fires for at least 1 hour. Drywall
used in the garage and party walls are to be fire rated,
5/8", Type X.
Fire
retardant chemical- A chemical or preparation
of chemicals used to reduce the flammability of a material
or to retard the spread of flame.
Fire
stop- A solid, tight closure of a concealed space,
placed to prevent the spread of fire and smoke through
such a space. In a frame wall, this will usually consist
of 2 by 4 cross blocking between studs. Work performed
to slow the spread of fire and smoke in the walls and
ceiling (behind the drywall). Includes stuffing wire
holes in the top and bottom plates with insulation,
and installing blocks of wood between the wall studs
at the drop soffit line. This is integral to passing
a Rough Frame inspection. See also 'Fire block'.
Fishplate
(gusset)- A wood or plywood piece used to fasten
the ends of two members together at a butt joint with
nails or bolts. Sometimes used at the junction of opposite
rafters near the ridge line. Sometimes called a gang
nail plate.
Fish
tape- A long strip of spring steel used for fishing
cables and for pulling wires through conduit.
Fixed
price contract- A contract with a set price for
the work. See Time and Materials Contract.
Fixed
rate- A loan where the initial payments are based
on a certain interest rate for a stated period . The
rate payable will not change during this period regardless
of changes in the lender's standard variable rate.
Fixed
Rate Mortgage- A mortgage with an interest rate
that remains the same over the years.
Flagstone
(flagging or flags)- Flat stones (1 to 4 inches
thick) used for walks, steps, floors, and vertical veneer
(in lieu of brick).
Flakeboard- A manufactured wood panel made out of 1"- 2"
wood chips and glue. Often used as a substitute for
plywood in the exterior wall and roof sheathing. Also
called OSB or wafer board.
Flame
retention burner- An oil burner, designed to
hold the flame near the nozzle surface. Generally the
most efficient type for residential use.
Flashing- Sheet metal or other material used in roof and wall
construction to protect a building from water seepage.
Flat
mold- Thin wood strips installed over the butt
seam of cabinet skins.
Flat
paint- An interior paint that contains a high
proportion of pigment and dries to a flat or lusterless
finish.
Flatwork- Common word for concrete floors, driveways, basements,
and sidewalks.
Floating- The next-to-last stage in concrete work, when you smooth
off the job and bring water to the surface by using
a hand float or bull float.
Floating
wall- A non-bearing wall built on a concrete
floor. It is constructed so that the bottom two horizontal
plates can compress or pull apart if the concrete floor
moves up or down. Normally built on basements and garage
slabs.
Fluorescent
lighting- A fluorescent lamp is a gas-filled
glass tube with a phosphur coating on the inside. Gas
inside the tube is ionized by electricity which causes
the phosphur coating to glow. Normally with two pins
that extend from each end.
Flue- Large pipe through which fumes escape from a gas water
heater, furnace, or fireplace. Normally these flue pipes
are double walled, galvanized sheet metal pipe and sometimes
referred to as a "B Vent". Fireplace flue
pipes are normally triple walled. In addition, nothing
combustible shall be within one inch from the flue pipe.
Flue
collar- Round metal ring which fits around the
heat flue pipe after the pipe passes out of the roof.
Flue
damper- An automatic door located in the flue
that closes it off when the burner turns off; purpose
is to reduce heat loss up the flue from the still-warm
furnace or boiler.
Flue
lining- 2-foot lengths, fire clay or terra-cotta
pipe (round or square) and usually made in all ordinary
flue sizes. Used for the inner lining of chimneys with
the brick or masonry work done around the outside. Flue
linings in chimneys runs from one foot below the flue
connection to the top of the chimney.
Fly
rafters- End rafters of the gable overhang supported
by roof sheathing and lookouts.
Footer,
footing- Continuous 8" or 10" thick
concrete pad installed before and supports the foundation
wall or monopost.
Forced
air heating - A common form of heating with natural
gas, propane, oil or electricity as a fuel. Air is heated
in the furnace and distributed through a set of metal
ducts to various areas of the house.
Form- Temporary structure erected to contain concrete during
placing and initial hardening.
Foundation- The supporting portion of a structure below the first
floor construction, or below grade, including the footings.
Foundation
ties- Metal wires that hold the foundation wall
panels and rebar in place during the concrete pour.
Foundation
waterproofing- High-quality below-grade moisture
protection. Used for below-grade exterior concrete and
masonry wall damp-proofing to seal out moisture and
prevent corrosion. Normally looks like black tar.
Frame
Inspection- The act of inspecting the home's
structural integrity and it's compliance to local municipal
codes.
Framer-The
carpenter contractor that installs the lumber and erects
the frame, flooring system, interior walls, backing,
trusses, rafters, decking, installs all beams, stairs,
soffits and all work related to the wood structure of
the home. The framer builds the home according to the
blueprints and must comply with local building codes
and regulations.
Framing- Lumber used for the structural members of a building,
such as studs, joists, and rafters.
Frieze- In house construction a horizontal member connecting
the top of the siding with the soffit of the cornice.
Frost
lid- Round metal lid that is installed on a water
meter pit.
Frost
line- The depth of frost penetration in soil
and/or the depth at which the earth will freeze and
swell. This depth varies in different parts of the country.
Furring
strips- Strips of wood, often 1 X 2 and used
to shim out and provide a level fastening surface for
a wall or ceiling.
Fuse- A device often found in older homes designed to prevent
overloads in electrical lines. This protects against
fire. See also 'circuit breakers'.